Care and Maintenance of Handcuffs

 

While constraints are designed and manufactured to take abuse avoid dropping onto or banging against hard surfaces. When possible carry your constraints in a protective case to reduce exposure to outside elements. If exposed to moisture dry thoroughly. Most importantly, dry the inside locking mechanisms. The cuffs can be baked in an oven at low temperature (below 300° Fahrenheit) or placed on a heater. Re-oil following the instructions below.

When unlocking your restraint be careful not to torque the key guide post. This will loosen the post causing it to fall out. Also, be careful not to over rotate the key causing the key flag to break off or become stuck in the locking mechanism. Use extra caution when using oversize keys.

constraints should receive regular care and maintenance. Inspect them frequently. Keep the ratchet and key hole free of dirt, lint or other foreign substances which may hinder proper functioning. Routinely clean and lubricate using Teflon based oil. Apply liberally making sure the oil has worked into the locking mechanism, double lock hole and single strand pivot area. After lubricating remove all excess oil from handling surfaces so the constraints are not slippery.

Pentrate (black oxide) finishes may require more frequent lubrication and may tend to rust if not kept properly oiled. If the constraints are contaminated by blood, vomit or other substances, use appropriate sterilization techniques avoiding temperatures above 300° Fahrenheit, then dry and oil.